Зубья на звёздочек ЧПУ

Anyway, guys, look at the topic. It

took me exactly one hour and 4 minutes to cut 57 teeth into stars. This is the kind of shavings I got. I did it with a number twenty cutter, four teeth. And now the most interesting and most important thing is that I need to cut exactly the same teeth on this part. I will unfold the part, and I need to

place it so that these teeth exactly match these ones. I'll show you now how I'm going to do it. That's it, guys, now the cherry on the cake. Look, I turned the part over , but I need these teeth to match up perfectly with these ones. How will I know this? How do I know this? No way.

I was lucky. My holes were made in one setup with these teeth. So I find zero in the center of this hole and I find the center of this hole. Then, look, the first hole, the second hole. I go to the center of the second hole and activate the coordinate system of the first hole. And then I

can see the distance by x and the distance by y. And then school rolls on. We recognize the corner rolling. Here is our corner. And now, guys, I'm taking an old program, this one . And at the beginning of the program I set a rotation, that is, a turn at this angle. And then I launch the old program.

And these, guys, teeth will perfectly match my new teeth. And the part will be ready. Now let's look at the manufacturing of the part. Milling of eight holes, diameter 160. And teeth on one side, teeth on the other side. To get a hole with a diameter of 160, I drilled with a 42 drill and then with an 84 cutter. It